Mactrac Curtain Track Bending
For Custom Bending
To make sure we get it right for
you first time, every time, please read
the following:
 |
When taking measurements, ensure you measure
from the fixing point. All other allowances for brackets
etc will be made during bending. |
|
Provide a separate diagram for each bent track. |
|
Provide the angle in degrees for all bends. If these
are not available, X and Y measurements are required,
along with the length of each section of track. |
|
It is possible to make slight adjustments to bent
tracks but these are minimal so ensure measurements
are accurate. |
|
Maximum total length of track is 5 metres. Tracks
over 5 metres will be supplied in two pieces which will
be joined on site. The best place for a join is where
the curtains meet. |
|
